7 – English
GLOSSARY OF TERMS
Activate (operating controls)
To move an operating control so that it is in a position that
allows the tool to be actuated or that satisfies one requirement
for the tool to be actuated.
Actuate (tool)
To cause movement of the tool component(s) intended to
drive a fastener.
Air inlet port
In an air tool, the opening to which the compressed air supply
is connected, usually by means of a threaded fitting.
Fastener
A staple, pin, brad, nail, or other fastening device which is
designed and manufactured for use in the tools within the
scope of this standard.
Jam
An obstruction in the feed or drive areas of the tool.
Maximum air pressure
The maximum allowable pressure of the compressed air, as
specified by the manufacturer, for operating a tool.
Operating control
A control that separately, or as part of an actuation system,
can cause the actuation of a tool.
Single sequential actuation
An actuation system in which there is more than one operating
control and the operating controls must be activated in a
specific sequence to actuate the tool. Additional actuation
can occur when a specific operating control, other than a
workpiece contact, is released and re-activated.
Trigger
A tool operating control activated by a tool operator’s fingers.
Workpiece
The intended object into which a fastener is to be driven
by a tool.
Workpiece contact
An operating control element or assembly on the tool intended
to be activated by the material to be fastened.
FEATURES
PRODUCT SPECIFICATIONS
Operating Pressure.............................................70-120 psi
Fastener Type ..................................... 16 gauge finish nails
Fastener Range ................................... 1-1/4 in. to 2-1/2 in.
Magazine Capacity ................................................100 nails
Air Consumption........................ 0..0941ft
3
/cycle at 100 psi
Air Inlet .............................................................. 1/4 in. NPT
Weighted sound impulse power level ................. 101.5 dBA
Weight ................................................................... 4.27 lbs.
KNOW YOUR STRAIGHT FINISH NAILER
See Figure 1, page 15.
The safe use of this product requires an understanding of the
information on the product and in this operator’s manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
ADJUSTABLE EXHAUST
The exhaust can be adjusted 360˚ depending on operator
preference.
DEPTH OF DRIVE ADJUSTMENT
The tool-free depth of drive adjustment lets the operator
select precise driving depth of the fastener.
DUST CAP
The dust cap helps prevent dust and debris from entering
the air fitting. Cover the air fitting with the dust cap when
not in use.
NO-MAR NOSEPIECE
The no-mar nosepiece prevents marring and denting when
using the tool on softer woods.
REAR-LOADING MAGAZINE
The rear-loading magazine allows easy three-step loading
of fasteners.
TRIGGER
Your finish nailer has a single sequential trigger for precise
fastener placement.
