HUSLOG
EN
16
HUSLOG
BLADE GREASING
Disconnect the power cord from the device if it is charging and make sure it is switched
off. Remove the comb attached to the cutting unit, then use your thumb to press the
cutting head from behind and carefully pull the blades with your other fingers. After
taking out the head, dot its blade with one or two drops of oil included in the kit. Spread
oil on the blades with a clean, dry cloth or paper towel. Remove any excess of oil. After
the blades have been oiled, the cutting unit can be reattached to the device body.
Once the supplied oil has been used up, use oil without acids, e.g. sewing machine
oil.
10. PROBLEMS
In case of any problems with the device, please refer to the following tips.
The device has no user-serviceable parts.
The device does
not switch on
Check that the device has been charged correctly. When the
battery is low, the charge indicator will blink red when an
attempt to switch it on is made.
The device does
not signal the
charging
Check that the power cord is properly connected.
Check the power cord for damage.
If the problem persists, contact the manufacturer's service department.
STORAGE OF EQUIPMENT
If you are not going to use the device for a long time, after disconnecting it from the
power supply and cleaning its components, store it in a dry room away from heat and
moisture sources. It is best to place the device in its original packaging, away from
children and pets.
TRANSPORT OF THE DEVICE
It is recommended to transport the device in its original packaging. Do not expose the
unit to excessive vibration or shock during transportation. During operation, only move
the unit when it is cleaned and disconnected from the power supply. Do not expose the
device to high temperatures or moisture.
12. WARRANTY AND SERVICE
The product is covered by a 2 year warranty from the date of sale of the product. In
case of a defect, the product should be returned to the shop where it was purchased,
remembering to provide the proof of purchase. The product should be complete and
in its original packaging.
11. STORAGE AND TRANSPORT
