4 Program
The programming function on your machine allows you to
create a stitch with your own personal settings and to
combine stitches and letters into stitch programs. You can
add up to 60 stitches and letters in the same program. Save
your own stitch or program in the machine memory and
recall it any time you like.
All stitches in your sewing machine are programmable except
for buttonholes, darning stitches, button sewing and bartacks.
Create a Stitch Program
Program mode
1. Press the program mode button (D) to open
programming.
2. The stitch menu which was previously selected will be
kept when entering the programming mode. To change
the stitch menu, press the stitch menu button (A) and
select another stitch menu by using the arrow buttons.
3. Press the number of the stitch you wish to use. The stitch
will appear in programming mode.
4. Press the number of the next stitch and it will appear to
the right of the last entered stitch.
Note: The number above the stitch program on the left side of the
graphic display is the number of the selected stitch. Two numbers are
displayed above the stitch program on the center of the graphic display.
The first number is the position of the selected stitch in the program. The
second number, put in parenthesis, is the total number of stitches in the
program.
Add Letters
5. Press the font menu button (B). Use the arrow buttons to
select a font and press OK. The machine will show the
upper case alphabet in programming mode.
6. Use the arrow buttons to select a letter and press OK to
add the letter to the program.
7. To switch to a lower case alphabet or numbers press the
shift button (C).
About Programming Letters
Above: “Husqvarna” and “VIKING” have been programmed
separately.
Below: “Husqvarna” and “VIKING” are in the same program.
Both upper and lower case letters will be stitched with a 7
mm stitch width. If there are letters going below the baseline
included in the program (e.g. j, p, y) the height of the
uppercase letters will be reduced.
All text to be sewn out on the same project, should be in the
same program to ensure the letters are sewn out in the same
height.
For instance, a name and an address should be in the same
program with a STOP after the name.
4 Program
41
Summary of Contents for Designer Jade 35
Page 1: ...User s Guide KEEPING THE WORLD SEWING ...
Page 82: ......
