• Keep first aid equipment near.
Safety devices on the product
For information about where to find the safety devices,
see
Introduction on page 2
.
WARNING:
Read the warning
instructions that follow before you use the
product.
• Do not use a product with defective safety devices.
Do a check of and do maintenance on the safety
devices regularly. If the safety devices are defective,
speak to your Husqvarna service agent.
• Do not make changes to safety devices. Do not
use the product if protective covers, safety switches
or other protective devices are not attached or are
defective.
• For all service and repair work on the product,
especially for the safety devices, special training is
necessary. If the safety devices fail the checks given
in this operator's manual, you must let a service
agent help you. We guarantee that professional
repairs and service is available. If your dealer is not
a service agent, speak to them for information about
the nearest service agent.
• Do not use a cutting attachment without an approved
and correctly attached cutting attachment guard. See
.
To do a check of the throttle trigger lockout
1. Push the throttle trigger lockout (A). Make sure that
the throttle trigger (B) is released.
B
A
2. Release the throttle trigger lockout (A). Make sure
that the throttle trigger (B) is locked at the idle
position.
3. Push the throttle trigger lockout (A) and make sure
that it goes back to its initial position when you
release it.
4. Start the product and apply full throttle. Refer to
.
5. Release the throttle trigger (B) and make sure that
the cutting attachment stops.
To do a check of the stop switch
1. Start the engine.
2. Move the stop switch to the stop position and make
sure that the engine stops.
To do a check of the cutting attachment guard
The cutting attachment guard prevents injuries and
stops objects that eject in the direction of the operator.
975 - 005 - 14.11.2022
7
