Husqvarna 142 152RB, User Manual

12 – 

English

ASSEMBLY

7

Bind the throttle cable (J) and the flexible shaft (K) with 
two bands (L).

Cable adjustment

•

The throttle cable should be paralleled to the flexible shaft. 
In case of twisting, they should be restored by parallel.

•

The throttle cable should be adjusted under the bent 
flexible shaft as shown.

1

Adjust the cable adjuster sleeve so the stop on the 
carburettor throttle cam just contacts the throttle stop and 
the cable position keep 1-2mm play between the cable lug 
and the slotted fitting when the throttle trigger is fully 
depressed.

2

When the throttle cable is adjusted correctly, tighten the 
lock-nut (G).

Assembling the cutting equipment

Assembling the spray guard

(Install the cord cutter and guard extension to the spray 
guard.)

1

Fasten the cord cutter (A) to the spray guard with two M5 
x 25 screws, lock washers and hex nuts as shown.

2

Attach the guard extension (B) to the guard with the five 
M5 x 25 screws, washers and hex nuts as shown.

Fitting a blade guard, grass blade and 
grass cutter

•

Fit the guard (A) to the gear housing using the support 
plate (M) and two screws (L).

•

Fit the drive disc (B) on the output shaft.

•

Turn the blade shaft until one of the holes in the drive disc 
aligns with the corresponding hole in the gear housing.

•

Insert the locking pin (C) in the hole to lock the shaft.

•

Place the blade (D), support cup (E) and support flange 
(F) on the output shaft.

•

Fit the nut (G). The nut must be tightened to a torque of 
35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool 
kit. Hold the shaft of the spanner as close to the blade 
guard as possible. To tighten the nut, turn the spanner in 
the opposite direction to the direction of rotation (Caution! 
left-hand thread).

!

WARNING!

When fitting the cutting attachment it is 
extremely important that the raised section 
on the drive disc/support flange engages 
correctly in the centre hole of the cutting 
attachment. If the cutting attachment is fitted 
incorrectly it can result in serious and/or 
fatal personal injury. 

!

WARNING! Never use a cutting attachment 
without an approved guard. See the chapter 
on Technical data. If an incorrect or faulty 
guard is fitted this can cause serious 
personal injury.

1-2mm

M

L

A

C

B

G

E

D

B

C

F