Husqvarna 1830EXLT, Operator'S Manual

6

ASSEMBLY / PRE-OPERATION

Read these instructions and this manual in its entirety before you attempt to assemble or operate your new 

snow thrower.  Reading the entire manual will familiarize you with the unit, which will assist you in assembly, 

operation and maintenance of the product.

Your new snow thrower has been as sem bled at the factory with the ex cep tion of those parts left unassembled for shipping 

purposes. All parts such as nuts, washers, bolts, etc., necessary to com plete the as sem bly have been placed in the parts 

bag. To ensure safe and proper operation of your snow thrower, all parts and hard ware you assemble must be tightened 

se cure ly. Use the correct tools as nec es sary to ensure proper tightness.

REMOVE SNOW THROWER FROM CAR TON

1.  Remove all accessible loose parts and parts boxes 

from carton.

2.  Cut down all four corners of carton and lay panels flat.
3.  Remove the two (2) screws securing the auger housing 

to the pallet.

4.  Remove all packing materials ex cept plastic tie holding 

speed control rod to lower handle.

5.  Remove the two (2) plastic ties securing the upper 

handle to the pallet.

6.  Remove snow thrower from carton and check carton 

thor ough ly for ad di tion al loose parts. 

HOW TO SET UP YOUR SNOW THROWER 

TOOL BOX (See Fig. 10)

A toolbox is provided on your snow thrower. The toolbox is 

located on top of the belt cover.  Store the extra shear bolts, 

nuts and multi-wrench provided in parts bag in the toolbox.

NOTE:

 The multi-wrench may be used for assembly of the 

chute rotator head to snow thrower and making ad just ments 

to the skid plates.

UNFOLD UPPER HANDLE

1.  Raise upper handle to the operating position and 

tight en handle knobs securely.  Additional carriage 

bolts, washers and handle knobs are in bag of parts.  

Use to secure upper handle to lower handle.  Install 

in lower holes in handles.

INSTALL SPEED CONTROL ROD (See Figs. 1 and 2)

1.  Remove plastic tie securing rod to lower handle.
2.  Insert rod into speed control bracket and secure with 

retainer spring.

SPEED

CONTROL 

ROD

HANDLE 

KNOB

LOWER 

HANDLE

PLASTIC TIE

UPPER 

HANDLE

FIG. 1

SPEED CON TROL ROD

SPEED 

CONTROL 

BRACKET

SPEED 

CONTROL 

LEVER

FIG. 2

RETAINER 

SPRING