Anti-Vibration System
9
System Description
The powerhead, bar and chain are isolated
from the front and rear handles by four shock
mounts. These shock mounts are designed to
reduce the vibration at the operator’s hands
which is generated by the powerhead and the
cutting equipment.
Replacement of the Shock Mounts
Empty fuel tank. Remove clutch cover, chain,
bar, cylinder cover, air filter and starter
assembly.
Disconnect fuel hose. On “G” models, discon-
nect leads from generator to handles at con-
nectors. Remove four shock mount screws.
Separate fuel tank assembly and front handle
from powerhead.
Remove the four shock mounts using 11 mm
spanner P/N 5025067-01. Install and secure
new shock mounts with 11 mm spanner.
IMPORTANT:
All 4 shock mounts must be
replaced as a set.
Position remaining two shock mounts and
reassemble saw.
33
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
