Crankcase and Crankshaft
12
Assembly
Thoroughly clean all parts before assembly.
Make sure the crankcase half mating surfaces
are clean and free of all gasket material. Heat
the bearing seat area of the ignition (left) side
crankcase half and install the crankshaft bear-
ing. Make sure the bearing is fully seated.
Heat the bearing seat area of the drive (right)
side crankcase half and install the crankshaft
bearing ensuring it is fully seated.
Using assembly tool P/N 5025030-07 pull the
crankshaft into the ignition side crankcase half
(left). Make sure the crankshaft is flush against
the bearing.
51
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com