S E R V I C E
8
97-05-29
10.
Thread the starter cord in the hole drilled by the carburettor housing in the crankcase.
11.
Coax the cord out through the hole drilled by the clutch cover. You can use a steel
wire with the end bent in a U to catch the cord. The short circuit cable hole just above
can be used to look through.
12.
Pull the protective hose right through the crankcase using the starter cord.
13.
Remove the grey protective cover from the cable harness on the right-hand side of
the tank.
14.
Remove the cover from the rear of the throttle (250 RX). Split the throttle (250R).
15.
Loosen the throttle cable from the cable pulley. Dismantle the short circuit cables with
the contact strip (250 RX). Unhook the throttle cable from the throttle trigger (250R).
16.
Remove the old throttle cable.
17.
Thread the cable through the black protective sheath first. Then thread the new
throttle cable through the plastic hose from the hole by the clutch cover and up to the
carburettor housing. Secure the clutch cover with the shaft on the engine.
18.
Fit the rubber grommet on the short circuit cables. Thread the cables through the
hole in the crankcase and out to the ignition module. Connect the cables on the
ignition module and press the rubber grommet in the crankcase. Check that the pole
gap between the flywheel and the module has not changed.
19.
Fit the carburettor and filter holder. Hook the throttle cable on the lever and secure
the wire sheath to the air filter holder.
20.
Slide back the suspension with the tank towards the engine. Insert the fuel pipe in the
hole in the crankcase. Fit the fuel pipe on the carburettor. Make sure the short circuit
cables are stretched.
21.
Secure the anti-vib springs between the tank and engine.
22.
Fit the throttle cable and short circuit cables in the throttle. See fig. 1. The U-shaped
nipple on the throttle (250RX) by the wire pulley should be fitted with the opening on
the nipple facing towards the throttle trigger.
23.
Fit the cylinder cover and starter.
The new throttle cables and plastic hose have the following part numbers:
502 28 60-04
Throttle cable 250 RX
502 22 89-01
Hose
502 27 93-04
Throttle cable 250R
English Page 2/3
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
