Husqvarna 326RJX Series, Operator'S Manual

English

 – 11

ASSEMBLY

Fitting the J-handle 

•

Clip the loop handle onto the shaft. Note that the loop 
handle must be 

fi

tted between the arrows on the shaft.

•

Slide the spacer into the slot in the loop handle.

•

Fit the nut, knob and screw. Do not overtighten.

•

Attach the J-handle to the loop handle using the three 
screws, as shown.

•

Now adjust the trimmer to give a comfortable working 
position. Tighten the bolt/knob.

Fitting blades and trimmer heads

When 

fi

tting the cutting attachment it is extremely important 

that the raised section on the drive disc/support 

fl

ange 

engages correctly in the centre hole of the cutting attachment. 
If the cutting attachment is 

fi

tted incorrectly it can result in 

serious and/or fatal personal injury.

Fitting a trimmer guard and 
Superauto II 1" trimmer head

•

Fit the correct trimmer guard (A) for use with the trimmer 
head. Hook the guard onto the 

fi

tting on the shaft and 

secure it with the bolt (L).

•

Fit the drive disc (B) on the output shaft.

•

Turn the blade shaft until one of the holes in the drive disc 
aligns with the corresponding hole in the gear housing.

•

Insert the locking pin (C) in the hole to lock the shaft.

•

To 

fi

t the trimmer head, 

fi

rst separate the two halves (see 

diagram). Proceed as follows:

•

Insert a 

fi

nger into the centre hole of the cover (I) while 

grasping the cover with your other 

fi

ngers. Using the index 

fi

nger and thumb of your other hand, release the two 

catches (J) that engage in the cut-outs in the bottom half 
(K). Pull apart the trimmer head, grasping the cover 

fi

rmly.

•

Place the cover (I) and the support 

fl

ange (F) on the 

output shaft.

•

Fit the nut (G). The nut must be tightened to a torque of 
35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool 
kit. Hold the shaft of the spanner as close to the blade 
guard as possible. To tighten the nut, turn the spanner in 
the opposite direction to the direction of rotation (Caution! 
left-hand thread). 

•

Fit the bottom half of the trimmer head (K) to the cover (I) 
by pressing them together, with the cut-outs on the bottom 
half aligned with the catches on the cover.

•

To dismantle, follow the instructions in the reverse order.

!

WARNING! Only grass blades/grass cutters 
or trimmer heads/plastic blades may be used 
when the J-handle is 

fi

tted. Saw blades must 

never be used with the J-handle.

!

WARNING! Never use a cutting attachment 
without an approved guard. See the chapter 
on Technical data. If an incorrect or faulty 
guard is 

fi

tted this can cause serious 

personal injury.

G

F

I

A

B

C

K

J

I

K