24
3
Fuel system
Assembly
1. Fit the rubber connection (A) on the
cylinder. Lubricate with oil so it
slides into the holes.
2. Fit the heat shield (B). Lubricate the
connection sleeves with oil so they
slide into the rubber connection.
Check that the bush (C) and brass
sleeves (D) are seated correctly.
Tighten the screws (E).
3. Fit the fuel hose (1) and both
pressure rods (2) and (3).
4. Place the carburettor in the air filter
cowling and located it with the
screws.
5. Insert the remaining fuel hose into
the tank.
6. Place the carburettor gasket in
position and tighten the carburettor
with the two screws.
7. Tighten the upper screw on the air
filter cowling in the heat guard.
Do not forget the washer under the
screw head.
8. Connect the throttle cable.
Assemble the remaining parts in the
reverse order as set out for dis-
mantling.
Throttle
Remove the bolt (A) and remove the
throttle from the handle.
Remove bolts (B) and (C).
Separate the halves of the throttle.
Throttle
Remove the bolt (A) that attaches the
throttle to the handle.
Be careful not to lose the nut.
Remove the throttle and remove bolts
(B) and (C).
Carefully separate the two halves of the
throttle.
Summary of Contents for 333R
