31
4
Centrifugal clutch
Clutch drum and drive
axle
Dismantling
Dismantle the clutch housing from the
shaft.
Clutch drum and drive
axle
Dismantling
Loosen the screw (A) and pull the
clutch housing off of the shaft.
Dismantle the connection sleeve.
Remove the 3 screws and lift off the
connection sleeve (B).
Twist apart the clutch and inspect the
different parts with regard to wear or
damage.
Twist apart the clutch.
Inspect the different parts with regard
to wear or damage.
Pay special attention to the ends of the
springs, which in addition to wear, can
also show signs of cracking.
Assembly
Connect the clutch shoes together with
the spring.
NOTE!
Both clutch shoes should be
replaced even if only one of them
is showing signs of heavy wear.
This is to avoid engine vibration
caused by imbalance in the clutch.
Bolt the clutch on the flywheel. Do not
forget the washers (A).
Note the slots on the washer lie closest
to the flywheel. Align with the
equivalent pins on the flywheel.
Summary of Contents for 333R
