51
7
Crankshaft and crankcase
Lift off the plastic piece that separates
the wide flush channel in the
crankcase.
Lift off the plastic piece that separates
the wide flush channel in the
crankcase.
Dismantle the ball-bearings from the
crankcase halves.
Dismantle the ball-bearings from the
crankcase halves.
Heat the crankcase halves to 110°C
using a hot air gun.
Dismantle the sealing rings from the
crankcase halves.
Dismantle the sealing rings from the
crankcase halves.
Use a suitable punch or sleeve and
knock out the sealing rings with the
help of a hammer. Do this while the
crankcase half is still warm if possible.
Now clean the crankcase halves and
crankshaft.
Knock the crankcase half against a
wooden block so that the ball-bearing
falls out.
Knock the crankcase half against a
wooden block so that the ball-bearing
falls out.
Summary of Contents for 333R
