ASSEMBLY
English
–
11
1157433-49 Rev. 2 2015-10-20
Fitting the loop handle
•
Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
•
Slide the spacer into the slot in the loop handle.
•
Fit the nut, knob and screw. Do not overtighten.
•
Now adjust the trimmer to give a comfortable working
position. Tighten the bolt/knob.
Assembling the angle gear
•
Assemble the angle gear back on the suppporting
tube. Turn the blade so that the drive shaft engages in
the angle gear.
Assembling the cutting
equipment
Assembling the blade
1
Fit the drive disc (A) on the outgoing shaft. Make sure
that the edge that fits in the hole of the blade is facing
outward.
2
Block the blade rotation by inserting the allen key (F)
in the hole behind the blade guard engaging it in the
corresponding hole in the drive disc.
3
Fit the blade (B) on the drive disc.
4
Fit the support flange (C). The support flange must be
fitted with its outer edge hard up against the blade.
5
Fit the two washers (D) and the locking screw (E).
6
Fit the locking screw. CAUTION! The locking screw
has a left-hand thread. Tighten the locking screw to a
torque of 15-20 Nm.
7
Remove allen key.
CAUTION!
Do not forget to remove the allen key before
using the machine.
!
WARNING!
When fitting the cutting attachment it is
extremely important that the raised
section on the drive disc/support flange
engages correctly in the centre hole of
the cutting attachment. If the cutting
attachment is fitted incorrectly it can
result in serious and/or fatal personal
injury.
!
!
WARNING! Under no circumstances may
the edge cutter blade be used without the
blade guard fitted.
F
B
A
C
D
E
