• Cut large branches in sections so that you have
better control over where they fall.
• Never cut through the swelling at the root of the
branch as this will slow down healing and increase
the risk of fungal attack!
• Use the stop at the base of the cutting head to
provide support during cutting. This will help prevent
the cutting attachment from ”jumping” on the branch.
• Make an initial cut on the underside of the branch
before cutting through the branch. This will prevent
tearing of the bark, which could lead to slow healing
and cause permanent damage to the tree. The cut
should not be deeper than 1/3 of the branch
thickness to prevent jamming. Keep the chain
running while you withdraw the cutting attachment
from the branch to prevent it jamming.
• Use the harness to support the weight of the
machine and make it easier to handle.
• Make sure you have a firm footing and that you can
work without being hampered by branches, stones
and trees.
WARNING:
Never activate the
throttle without having the cutting
attachment in full view.
To prepare the product for start
1. Push the air purge bulb 10 times.
Note:
It is not necessary to fully fill the bulb.
2. Move the choke control up into choke position.
WARNING:
The saw chain will start
to rotate immediately when you start the
engine with the choke.
To start the product
WARNING:
Read the warning
instructions in the safety chapter before you
start the product (refer to
).
1. Use protective gloves.
2. Hold the body of the product on the ground with your
left hand.
CAUTION:
Do not use your feet!
3. Hold the starter rope handle with your right hand.
4. Slowly pull out the starter rope with your right hand
until you feel some resistance (the starter pawls
grip).
WARNING:
Do not twist the starter
rope around your hand.
5. Pull the cord quickly and with power.
14
712 - 007 - 28.04.2021
Summary of Contents for 525PT5S
