CAUTION:
Do not use leaded gasoline.
This can cause damage to the product.
• Always use new unleaded gasoline with a minimum
octane number of 90 RON (87 AKI) and with less
than 10% ethanol concentration (E10).
• Use gasoline with a higher octane number if you
frequently use the product at continuously high
engine speed.
• Always use a good quality unleaded gasoline/oil
mixture.
Two-stroke oil
• For best results and performance use Husqvarna
two-stroke oil.
• If Husqvarna two-stroke oil is not available, use a
two-stroke oil of good quality for air-cooled engines.
Speak to your servicing dealer to select the correct
oil.
CAUTION:
Do not use two-stroke
oil for water-cooled outboard engines,
also referred to as outboard oil. Do not
use oil for four-stroke engines.
To mix gasoline and two-stroke oil
CAUTION:
There is a risk that small
errors influence the ratio of the mixture
drastically when you mix small quantities of
fuel. Carefully measure the quantity of oil
to be mixed to make sure that you get the
correct mixture.
1. Fill half the quantity of the gasoline to be used.
2. Add the full quantity of oil and mix (shake) the fuel
mixture.
3. Add the remaining quantity of gasoline.
4. Carefully mix (shake) the fuel mixture and fill the fuel
tank of the product.
5. Empty and clean the fuel tank if you do not use the
product for some time.
Note:
Do not mix fuel for more than 1 month at a time
and always mix gasoline and oil in a clean container
intended for fuel.
To add fuel
WARNING:
Do not smoke or put hot
objects near fuel. Before you add fuel, stop
the engine and let it cool for minutes.
WARNING:
When you add fuel, open
the fuel tank cap slowly to release unwanted
pressure.
WARNING:
After you add fuel, tighten
the fuel tank cap carefully. Move the
machine away from the refuelling area and
the power before you start the engine.
• Always use a fuel container with an anti-spill valve.
• Make sure that the area near the fuel tank cap
is clean. Contamination in the tank can cause
operating problems.
• Shake the fuel container before you add the fuel
mixture to the fuel tank.
To start and stop
Before you operate the product
• Examine the work area to make sure that you know
the type of terrain, the slope of the ground and if
there are obstacles such as stones, branches and
ditches.
• Do an overhaul inspection of the product.
• Do the safety inspections, maintenance and
servicing that are given in this manual.
• Make sure that all covers, guards, handles and the
cutting equipment are correctly attached and not
damaged.
• Make sure that there are no cracks at the bottom of
the grass blade teeth or by the center hole of the
blade. Replace the blade if it is damaged.
46
1756 - 001 - 08.06.2022
Summary of Contents for 533RS
Page 781: ...1 3 8 7 4 5 2 Tri Cut 1756 001 08 06 2022 781 ...
Page 786: ...786 1756 001 08 06 2022 ...
Page 787: ...1756 001 08 06 2022 787 ...
