4
FIGURE 4
4.
Align jack lift assembly hole “B” with clear-
ance holes in frame and attach jack assem-
bly to bracket on axle using 3/8” x 1 1/2”
bolt and 3/8” washers and lock nut. See
Figure 4.
5.
Tighten the 1/2” bolt and 3/8” bolt securely.
The 3/8” bolt will require the use of a 9/16”
deep-well socket wrench to tighten.
FIGURE 5
6.
Install tow bar by sliding bracket into frame
mount and aligning holes. See Figure 5.
FIGURE 6
7.
Insert four 3/8” x 1” bolts, four washers
placed on outside of frame and four 3/8”
lock nuts. Tighten securely with socket
wrench. See Figure 5.
FIGURE 7
8.
Test the operation of jack lift assembly by
raising transport wheels to highest position
prior to tipping aerator into operating posi-
tion. Lower transport wheels fully before tip-
ping aerator.
7.
Attach the tie bars to the aerator bed and
to the tow bar as seen in Figure 6. (48”
model only.)
1
B
ASSEMBLY
TIE BAR
