• Only do the maintenance as this operator's manual
recommends. Let an approved Husqvarna service
agent do all other servicing.
• Let an approved Husqvarna service agent do
servicing on the product regularly.
• Replace damaged, worn or broken parts.
Assembly
Introduction
WARNING:
Before you assemble the
product, you must read and understand the
safety chapter.
WARNING:
Remove the spark plug
cable from the spark plug before you
assemble the product.
To attach the throttle handle
Note:
On some models, the throttle handle is attached
at the factory.
1. Remove the nut and screw at the bottom of the
throttle handle.
2. Put the throttle handle onto the right side of the
handlebar.
3. Align the screw hole in the throttle handle with the
hole in the handlebar.
4. Put the screw into the hole at the bottom of the
throttle handle, through the handlebar.
5. Put back and tighten the nut.
To assemble the handlebar
1. Remove the knob and attach the handlebar as given
in the illustration.
2. Tighten the knob lightly.
3. Put on the harness and hang the product from the
suspension point.
4. Adjust the handle to put the product in a comfortable
work position.
5. Tighten the knob fully.
To set the handlebar in transport
position
1. Loosen the knob.
2. Turn the handlebar clockwise until the throttle handle
touches the battery.
3. Turn the handlebar around the shaft.
1346 - 004 - 03.06.2021
11
Summary of Contents for 555FRM
Page 111: ...1346 004 03 06 2021 111 ...
