Husqvarna 750, Operator'S Manual

10

Engine Oil

Checking, Adding and Changing Oil

Check the engine oil level (B) daily with saw fully lowered and 

the engine level. See the enclosed Robin manual for more 

details.

Use SAE 10W-30 viscosity detergent automotive type with API 

service class SE or higher grade oil.

Note: 

Engine holds approximately 0.6 quart (0.6 liter) when 

changing.

Changing the Oil 

Change oil after the first 5 to 8 hours of use.

Thereafter every 50 hours. 

ENGINE AND TRANSMISSION MAINTENANCE 

The oil drain hose (A) is located at the front of the saw.

1. With the engine OFF but still warm, remove the brass cap 

and drain the oil in a pan.

2. Replace the brass cap on the oil drain hose.

3. Fill the engine at the oil fill cap (B) with 0.6 quart (0.6 liter) of 

oil. When full, the oil level should be at the high level mark on 

the dipstick or to the top of the threads on the engine fill hole.

The engine is equipped with an oil alert system that will stop 

the engine if the oil level is low.

A

NOTICE

Used oil is a hazardous waste product.  Dispose of 

used oil properly.  Do not discard with household 

waste.  Check with your local authorities, service  

center, or dealer for safe disposal/recycling facility

.

ADDITIONAL ENGINE INFORMATION

Please see the Robin Operator’s Manual for additional 

information about servicing the engine.

The manual also has specific information about specifications, 

tune-up parts, engine warranty, emission compliance, etc.

C

B

Air filter

The air cleaner assembly (C) is a cyclone type on the engine 

at the front of the saw. The air cleaner element should be 

replaced every 50 hours. Refer to the supplied engine manual 

and the “Cyclone Dual-Filter-Element Type” for additional 

information.

Transmission oil

Check the transmission oil level daily. The transmission is 

accessible from the rear of the saw. The oil reservoir (D) 

located on the top of the transmission has an oil level line 1/8” 

(3 mm) from the bottom of the reservoir to indicate the proper 

fluid level when cold. Use hydraulic oil 20W with viscosity of 68 

Mobil DTE 26 or equivalent.

Transmission neutral

With the saw control lever pulled back towards the operator, 

the saw should fully stop and not creep or move. To adjust the 

transmission neutral position, loosen the lock nut on the cable 

end (E) at the transmission. Pull the spring sleeve back and 

adjust the swivel until the saw fully stops moving. Tighten the 

lock nut.

D

E