Husqvarna 960 73 00-25, Owner'S Manual

5

ASSEMBLY

1

DRAWBAR A (See Figs. 1A, 1B & 1C)

1.  Remove and discard the upper bolt on both sides of 

the drawbar. Using the same holes, install the shoulder 

bolts supplied and tighten securely.

0

2

5

31

DRAWBAR

FIG. 1A

REMOVE AND DISCARD

UPPER BOLTS AND INSTALL

SHOULDER BOLTS SUPPLIED

0

25

30

SHOULDER

BOLTS

SUPPORT 

ASSEMBLY

RETAINER 

SPRING

PIN

FIG. 1C

2.  Install adapter to both sides of support assembly as 

shown.

BAGGER SUPPORT ASSEMBLY         

Determine which type drawbar you have on your tractor.
Compare the drawbar illustrations below to the drawbar 

located at the rear of your tractor.
Follow the support assembly instructions that apply to your 

type drawbar from the four listed below.  Please note draw-

bars A and B are vertical, while C and D are angled.

DRAWBAR A

DRAWBAR B

3.  Align support assembly pin with hole in drawbar and 

hang assembly over the shoulder bolts.

4.  Be sure support assembly is seated properly and secure 

with retainer spring supplied.

FIG. 1B

ADAPTER

DRAWBAR C

DRAWBAR D

If your tractor is equipped

with this illustration call

1-800-633-3522

for a replacement kit.