![background image](http://html.mh-extra.com/html/husqvarna/96083001100/96083001100_operators-manual_173133016.webp)
16
SERVICE AND ADJUSTMENTS
• Wrap V-belt around reverse idler pulley and reassemble
idler to idler arm. Tighten securely. Be sure belt is
between reverse idler pulley and idler arm pin.
• Install belt to outside groove of transmission pulley. Be
sure belt is inside all belt guides and rests on outside
groove of engine pulley.
CHECK TINE OPERATION
• See “TINE OPERATION CHECK” in this section of
manual.
REPLACE BELT GUARD
Fig. 22
FORWARD MOTION
(INSIDE) V-BELT
ENGINE PULLEY
BELT GUIDE
REVERSE IDLER ARM
REVERSE IDLER PULLEY
IDLER ARM PIN
TRANS MIS SION
PUL LEY
FOR WARD IDLER PUL LEY
REVERSE (OUTSIDE)
V-BELT
BELT GUARD BOLT
ENGINE
TO AD JUST CARBURETOR
The carburetor has been preset at the factory and cannot
be adjusted.
IMPORTANT:
NEVER TAMPER WITH THE ENGINE GOVERNOR,
WHICH IS FACTORY SET FOR PROPER ENGINE SPEED. OVER-
SPEED ING THE ENGINE ABOVE THE FACTORY HIGH SPEED
SETTING CAN BE DANGEROUS. IF YOU THINK THE ENGINE-
GOVERNED HIGH SPEED NEEDS ADJUSTING, CONTACT YOUR
NEAREST AUTHORIZED SERVICE CENTER/DEPARTMENT,
WHICH HAS THE PROPER EQUIP MENT AND EXPERIENCE TO
MAKE ANY NEC ES SARY ADJUSTMENTS.
Summary of Contents for 96083001100
Page 19: ...19 SERVICE NOTES ...
Page 20: ...05 09 18 SR Printed in U S A ...