OPERATION
27
Before Starting
1. Read the sections on
Safety
and
Controls
before
starting the machine.
2. Perform the daily maintenance before starting
(see
Maintenance Schedule
in the
Maintenance
section).
3. Check that there is sufficient fuel in the fuel tank.
4. Adjust the seat to the desired position.
Roll Bar and Safety Belt
Operate the unit with the roll bar in the raised and
locked position and use the seat belt. There is no
rollover protection when the roll bar is down. If it is
necessary to lower roll bar, do not wear the seat belt.
Raise the roll bar as soon as clearance permits.
8065-011
Roll bar in upright position
WARNING!
The seat belt must be used when the roll
bar is in upright position.
8065-110
Seat adjustment
8065-016
Set deck to selected cutting height
5. Set the pin at desired cutting height. Height
selection pin is removed by rotating 180
O
. Make
sure that the pin is inserted fully through the both
sides of the height panels.
The following conditions must be fulfilled before the
engine can be started:
• The blade switch for engaging the mower blades
must be depressed.
• The parking brake must be on.
• Both steering controls must be in the locked
(outer) neutral position.
Summary of Contents for 966614003
Page 55: ...WIRING DIAGRAM 55 TIMER SCHEMATIC ...
Page 67: ......
Page 68: ...115 520727 Rev A 2012 10 30 www husqvarna com ...