General
Remove the ignition key to prevent unintentional
movements during lubrication.
When lubricating with an oil can, it must be filled
with engine oil.
When lubricating with grease, unless otherwise
stated, use high grade molybdenum disulphide
grease.
For daily use, the machine must be lubricated
twice weekly.
Wipe away excess grease after lubrication.
It is important to avoid getting lubricant on the
belts or the drive surfaces on the belt pulleys.
If this happens, clean them with spirits. If the
belt continues to slip after cleaning, it must be
replaced. Gasoline or other petroleum products
must not be used to clean belts.
*
Change hydraulic drive filters.
p
Change engine oil every 50 hours.
12/12
Every year
Lubricate with grease gun
1/52
Every Week
Filter change
1/365
Every day
Oil change
Level check
Lubrication Schedule
IMPORTANT INFORMATION
Use minimal
lubrication and remove excess lubricant so that
is does not come into contact with belts or belt
pulley drive surfaces.
WARNING
! Escaping hydraulic oil
under pressure can have sufficient force to
penetrate the skin, causing serious injury. If
injured by escaping fluid, see a doctor at once.
Serious infection or reaction can develop if
proper medical treatment is not administered
immediately.
28
LUBRICATION
Summary of Contents for 97045560100
Page 33: ...33 SCHEMATIC ...
Page 74: ...74 ESQUEMA ...
Page 83: ......
Page 84: ...2019 10 15 SR ...