•
Operate the product counterclockwise around the
boundary of the stay-out zone.
•
Add waypoints on the map. Add the waypoints
minimum 3 cm / 1 in. from obstacles.
•
Do not set waypoints that make a virtual boundary
go across itself in the same stay-out zone.
•
Save the work area to automatically connect the
first and last waypoint with a virtual boundary.
To make a transport path
•
Operate the product and add waypoints on the
map to install a transport path. Start in a work area
minimum 1 m / 3.3 ft. from the virtual boundary.
•
Do not install a transport path across a stay-out
zone.
•
Do not set waypoints that make the transport path
go across the same transport path.
•
Operate the product and add waypoints to connect
the transport path to the docking point.
•
Save the transport path to automatically connect
the last waypoint to the docking point.
•
Set the corridor width (A) for the transport path.
The corridor width can be set to 2-5 m / 6.6-16.4 ft.
A
To make a maintenance point
•
Operate the product and add waypoints on the
map. Start to add waypoints at the position
where you install the maintenance point. The first
waypoint specifies the maintenance point.
•
Operate the product and add waypoints to make a
path to the charging station.
•
Save the maintenance point to automatically
connect the last waypoint to the docking point.
•
Set the corridor width (A) for the maintenance
point. The corridor width can be set to 2-5 m /
6.6-16.4 ft.
A
3.9 Settings
The product has factory settings but the settings can be
adapted to each work area.
3.9.1 Schedule
In
Schedule
menu you can change the schedule settings
for the product. The
Schedule
is set for each work area
that is connected to the charging station.
Secondary
areas
cannot be scheduled.
The schedule function controls which hours the product
is permitted to operate. When the product does not
operate it is parked in the charging station. You can
see which hours and days the product operates in the
schedule overview in the app.
The factory schedule setting lets the product to operate
around the clock 7 days a week.
To calculate the schedule setting, refer to
the schedule setting on page 18
.
3.9.1.1 To calculate the schedule setting
1.
Calculate the dimension of your lawn in m
2
/ ft
2
.
2.
Divide the m
2
/ ft
2
of the lawn with the approximate
operation capacity. Refer to table below.
3.
The result is equal to the number of hours that the
product must operate each day.
18 - Installation
1970 - 001 - 10.10.2022
