To stop the product
1. Release the quick stop handle (A). The motor stops.
A
2. Disconnect the power cord from the power source.
WARNING: Always disconnect the
power cord from the power source when
the product is not in operation.
Maintenance
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
For all servicing and repair work on the product, special
training is necessary. We guarantee that professional
repairs and servicing is available. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
For spare parts, speak to your Husqvarna dealer or
service agent.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
Maintenance
Daily, be-
fore use
Daily, after
use
After the
first 20 h
Monthly,
each 200
h
Yearly,
each 500
h
Make sure that there are no oil leaks.
*
Clean the product.
X
Make sure that nuts and screws are tightened.
*
Lubricate the blade shafts after the product is
cleaned.
X
X
Make sure that the controls can move smoothly.
*
Examine the wires for damage and make sure that
they are correctly adjusted.
*
Examine the V-belt for damage.
X
X
Clean the blade shaft.
X
Clean the pressure plate.
X
To clean the product
• Remove concrete from the surfaces of the product
after each operation before the concrete becomes
hard.
• Use a high-pressure washer to clean the product.
CAUTION: Do not point the water
directly at the motor.
• Remove grease and oil from the handle.
1132 - 001 - 06.04.2020
9
