To adjust the angle of the tool
1. Operate the control switches for the tool angle to
adjust the angle of the tool.
B
A
a) Push the tool lift switch (A) on the left wheel
control to decrease the angel of the tool.
b) Push the button (B) on the right wheel control to
increase the angel of the tool.
To adjust the height of the tool
1. Operate the tool height switch to adjust the height of
the tool.
To start the product
WARNING:
Make sure that the work
area is safe before you stop the product.
.
1. Push the OFF switch. Refer to
page 3
.
2. Release the seat belt.
3. Leave the seat.
4. Disonnect the product.
To remove a soft floor surface
WARNING:
Use protective gloves. The
blades are very sharp.
Note:
Short blades cut the floors easier than long
blades. Long blades are not always better or faster. A
short blade usually cleans the floor better than a wide
blade.
Note:
The blades are sharp for a longer time if the
work area is clean from unwanted material.
1. Use personal protective equipment. Refer to
Personal protective equipment on page 6
.
2. Install a blade of the correct type. Refer to
the correct blade dimension and installation position
on page 9
and
To replace the blade on page 15
.
WARNING:
Use protective gloves.
The blades are very sharp.
3. Make sure that the blade is sharp. Sharpen the
blade if it is necessary. Refer to
blade on page 15
.
4. Cut linear ditches in the floor 1200 to 1800 mm
apart.
1817 - 002 - 13.04.2022
11
