• Use approved respiratory protection. Make sure
that the respiratory protection is applicable for the
dangerous materials in the work area.
• Make sure that the airflow is sufficient in the work
area.
• If it is possible, point the exhaust of the product
where it cannot cause dust to go into the air.
Safety instructions for maintenance
WARNING:
Read the warning
instructions that follow before you use the
product.
• Use personal protective equipment. Refer to
Personal protective equipment on page 6
.
• Only do the maintenance as given in this operator's
manual. Let an approved service agent do all other
servicing.
• If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
• Clean the product to remove dangerous material
before you do the maintenance.
• Push the emergency stop button before you do the
maintenance.
• Do the maintenance of the product on stable level
ground.
• Do not do modifications to the product. Modifications
that are not approved by the manufacturer can
cause serious injury or death.
• Replace damaged, worn or broken parts.
• Always use original accessories and spare parts.
Accessories and spare parts that are not approved
by the manufacturer, can cause serious injury or
death.
• After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service agent.
• Let an approved service agent do servicing on the
product regularly.
Operation
Introduction
WARNING:
Before you operate the
product, you must read and understand the
safety chapter.
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Read the operator's manual for the dust extractor
carefully and make sure that you understand the
instructions.
3. Use personal protective equipment. Refer to
Personal protective equipment on page 6
.
4. Do daily maintenance. Refer to
.
5. Make sure that the product is assembled correctly
and is not damaged.
6. Make sure that only approved persons are in the
work area.
7. Connect the product to a mains socket. Refer to
connect the product to a power source on page 10
.
8. Put the product on the work area. Make sure that
the transportation of the product to and in the work
area is done safely and correctly. Refer to
.
9. Install a tool. Refer to
15
. Make sure that the tool has the correct angle
and pitch for the operation.
10. Make sure that the blade is sharp. If it is necessary,
replace or sharpen the blade. Refer to
and
page 15
.
11. If you use a self-scoring blade, make sure that the
angles at the ends of the blade (A) are sharp.
A
To select the correct blade dimension
and installation position
WARNING:
Use protective gloves. The
blades are very sharp.
All available blade types can be used for the approved
materials: hardwood, ceramics, linoleum, vinyl, carpet,
Blades on page 23
.
It is necessary to select correct dimension and
installation of the blade for the material to remove and
the subfloor type. Blades of different dimension can be
necessary during the same work operation.
1817 - 002 - 13.04.2022
9
