22
English
- Check fuel and oil level.
• ELECTRIC VERSION.
Check the following:
ELECTRICAL SAFETY :
Operate this machine only on a supply
equipped with a 30 mA earthed current-
limiting circuit-breaker. Otherwise,
consult our catalogue for appropriate
models.
• PETROL VERSION.
Consult the engine
maintenance manual.
Take into account the working conditions
from health and safety point of wiew.
- To start the engine, refer to the engine
operating instructions and paragraph 7
"Starting up".
- Check the mains voltage (SINGLE PHASE, 230
V - THREE PHASE 400 V).
- Check that the motor is connected to electric
cable with conductors of 4 mm
2
section (single
phase) and 2.5 mm
2
(three phase) for lengths
less than 100 m. Above this length, double the
section.
- THREE PHASE : Check that the motor is
turning in the same direction as that of the
arrow located on rear cover of the motor (if not,
reverse 2 of the wires).
- To start the motor, refer to paragraph
7 "Starting up".
Always take care.
Get into a comfortable, balanced
position.
Remove all adjustment tools and
wrenches from floor and machine
• PETROL VERSION:
- Refer to the manufacturers manual.
- Let the engine warm up.
• ELECTRIC VERSION:
- The planer is operated by the on/off switch
(emergency stop using the handle
(I)
).
•
DUST EXTRACTOR:
- Fit the suction
(U
) hose directly onto connector
located on the back of the machine (health and
safety) [
SEE FIG.
5].
7
Starting up
To start the planer, grasp the dead
man’s handle (I) on the steering shaft.
The motor stops if this is released. As
a safety precaution, check regularly
that it operates correctly. Do not lock
it in position.
• To mill concrete, pass the machine over several
times according to the nature of concrete and
until desired result is obtained.
•
Millimetric depth adjustment [
SEE FIG.
6]
:
- Action the fly-wheel
(C)
that will act on the
screw
(D)
.
- Turn the nut
(E)
to lock the screw and secure
the cutting depth.
•
Quick release:
- Pull lever
(B)
backwards to release the drum
quickly.
- And push forwards at the preselected depth to
resume work.
8
Working procedure
• Check periodically belt tension and retighten it
when necessary but do not overtighten, by
means of the nut
(S)
and lock nut
(T)
[
SEE
FIG.
x
7].
9
Belt tensioning
Never set belts beyond original
tension
