22
• From the rear of the tractor, slide the lower clevis assembly
(12) onto the right side bagger support tube (10). Line up the
center hole (13) on upper bracket with the hole in the bagger
support tube (10) and secure lower clevis assembly (12) with
clevis pins (14) and clips (15).
• Install the actuator (16) as shown. Use the spacers (17) to
center the actuator (16) between both the upper and lower
brackets and secure with clevis pins (18) and clips (19).
TO INSTALL BAGGER SPRING LATCH
The bagger spring latches are located on the back plate (1),
one in each of the bottom corners.
Before installing, tractor engine must be shut off and parking
brake engaged.
• Install each bagger spring latch with the loop end (2) down
and facing towards the bagger assembly.
• Place the mounting bolt (3) through the backplate. Place
curved end of the bagger spring latch onto mounting bolt (3)
and secure with nut (4) as shown. Tighten firmly.
BAGGER SPRING LATCH ADJUSTMENT
If the bagger assembly height is adjusted, it may be necessary
to adjust the bagger spring latch. To adjust, remove the nut (4)
and move the bagger spring latch to the appropriate hole in the
backplate (1), ensuring the bagger assembly will be securely
closed. Retighten nut securely.
NOTE:
The bottom of the bagger assembly should contact the
loop end so that it is held securely when closed.
TO INSTALL BAGGER FULL LEVER/EXTENSION
Before installation or adjusting, tractor engine must be shut off
and parking brake engaged.
• Remove center discharge chute. (See "To Remove Center
Chute" in section 6 of this manual.)
• Remove bolt (1). Place lever (2) into slot and reinstall bolt
(1). Adjust as needed.
TO ADJUST BAGGER FULL LEVER/EXTENSION
Slide bagger full extension (3) to the desired position.
• For the heaviest/wet grasses, slide extension all the way in.
• For the lightest/driest grasses, pull extension all the way out.
• Route cable assembly (20) between the lower clevis assem-
bly (12) and along bagger support tube (10), and connect the
cable assembly (20).
• Using the switch (21) on the right side fender, fully extend
the actuator (16). Secure any excess cable assembly to
the bagger support tube (10) with the zip ties (22). Retract
the actuator (16) and check to ensure there are no snags or
binds in the cable assembly (20).
• Install the bagger assembly.
NOTE:
Both cross tubes (23) on the bagger support weldment
need to be placed onto the top support assemblies (24). Extend-
ing the actuator slightly will help make installation easier. Once
installed, adjust bagger assembly as needed. (See "To Adjust
Bagger" in this section of the manual.)
23
24
21
16
16
22
10
20
12
10
20
2
1
3
4
14
15
10
13
12
18
17
16
18
19
19
2
1
2
3
