Husqvarna CTH19530, Operator'S Manual

26

Fig. 46

SERVICE AND ADJUSTMENTS

Fig. 45

TO REPLACE MOWER BLADE DRIVE BELT 

(See Fig. 45)

The mower blade drive belt may be replaced without tools.  

Park the tractor on level surface.  Engage parking brake.  
BELT REMOVAL -
•  Remove mower from tractor (See “TO REMOVE 

MOW ER” in this section of manual).

•  Work belt off mandrel pulley and idler pulleys.
•  Pull belt away from mower. 
BELT INSTALLATION -
•  Work belt around mandrel pulley and idler pulleys.
•  Make sure belt is in all pulley grooves and in side all 

belt guides.

•  Install mower (See "TO INSTALL MOWER" in this 

section of manual).

IDLER

PUL LEYS

MANDREL

PULLEY

TO REPLACE MOTION DRIVE BELT

(See Fig. 46)

Park the tractor on level surface. En gage parking brake. 

For as sis tance, there is a belt installation guide decal on 

bottom side of left footrest.
BELT REMOVAL -
1.  Remove mower. (See “TO REMOVE MOWER” section 

in this manual.)

NOTE:

 Observe entire motion drive belt and position of all 

belt guides and keepers.
2.  Disconnect clutch wire harness (A).
3.  Remove anti-rotation link (B) on right side of tractor.
4.  Remove belt from stationary idler (C) and clutching idler (D).
5.  Remove belt from centerspan idler (E).
6.  Pull belt slack toward rear of trac tor. Carefully remove 

belt up wards from trans mis sion input pulley and over 

cooling fan blades (F).

7.  Remove belt downward from engine pulley and around 

electric clutch (G).

8.  Slide belt toward rear of tractor, off the steering plate 

(H) and remove from tractor.

1.  Install new belt from tractor rear to front, over the steer-

ing plate (H) and above clutch brake pedal shaft (J).

2. Pull belt toward front of tractor and roll belt around 

electric clutch and onto engine pulley (G).

3.  Pull belt toward rear of tractor. Carefully work belt down 

around transmission cooling fan and onto the input pul-

ley (F). Be sure belt is inside the belt keeper.

4.  Install belt on centerspan idler (E).
5.  Install belt through stationary idler (C) and clutch ing idler (D).
6.  Reinstall anti-rotation link (B) on right side of tractor. 

Tighten securely.

7.  Reconnect clutch harness (A).
8.  Ensure belt is in all pulley grooves and in side all belt 

guides and keep ers.

9.  Install mower. (See “TO INSTALL MOWER” section in 

this manual.)

E

A

F

B

J

G

C

H

D

TO CHECK BRAKE 

If tractor requires more than five (5) feet (1,5 m) to stop at 

highest speed in high est gear on a level, dry concrete or 

paved surface, then brake must be serviced.
You may also check brake by:
1.  Park tractor on a level, dry concrete or paved surface, 

depress brake pedal all the way down and engage 

parking brake.

2.  Disengage transmission by placing freewheel control 

in “transmission disengaged” position. Pull freewheel 

control out and into the slot and release so it is held in 

the disengaged position.

The rear wheels must lock and skid when you try to manually 

push the tractor forward. If the rear wheels rotate, then the 

brake needs to be serviced. Contact a qualified service center.