Operation
Before you operate the product
WARNING: This machine is designed for
and intended for drilling concrete, brick and
different stone materials. All other use is
improper.
WARNING: Before drilling, check that all
locking screws are tightened well. Serious
accidents can occur if the concrete core
remains in the drill when backing out the drill
motor/drill from the floor, wall or ceiling.
WARNING: When drilling ceilings, always
use a water collector that is approved for
your drill motor, or use a hydraulic drill
motor. There is a risk that the drilling
machine and the stand become live if water
leaks into the machine.
WARNING: Make sure end stop is fitted and
functional.
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Keep the work area clean and bright to prevent
accidents.
3. Do daily maintenance. Refer to
the drill stand on page 23
.
4. Use personal protective equipment. Refer to
Personal protective equipment on page 17
.
To adjust the angle of the drill column
1. Loosen the lock screw that locks the drill column and
set the applicable drill angle.
2. Use the angle indicator for approximate adjustment.
If higher precision is necessary, use alternative
methods to measure.
3. Tighten the lock screw of the drill column. Use the
feed lever. The drill column can be tilted 0-90°.
Maintenance
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
WARNING: To prevent injury, disconnect the
power cord before you do maintenance.
Daily maintenance of the drill stand
• Make sure that the nuts and screws are tight.
• Clean the external surface of the drill stand.
• Make sure that the feed lever moves without
resistance.
• Make sure that the gears move easily and do not
cause a noise.
• Examine the drill column, look for wear or damage.
• Make sure that the drill motor carriage moves easily
and that there is no play against the drill column.
To clean and lubricate the drill stand
CAUTION: If you do not clean the drill stand,
it can become damaged.
1. Remove the drill motor.
2. Clean the drill stand with a high pressure washer
and then remove remaining water with a dry cloth.
3. Lubricate the moving parts on the drill stand. Apply
grease to the contact surfaces to prevent corrosion.
922 - 002 - 06.03.2019
23
