• Keep the batteries away from sunlight, heat or open
flame. The batteries can cause an explosion and
cause burns and/or chemical burns.
• Keep the batteries away from rain and wet
conditions.
• Keep the batteries away from microwaves and high
pressure.
• Do not try to disassemble or break the batteries.
• Use the batteries in ambient temperatures between
-20°C/-4°F and 60 °C/140°F.
• Charge the batteries in ambient temperatures
between 10°C/50°F and 45°C/113°F.
• Do not clean the batteries or the battery charger with
water. Refer to
To clean the batteries and the battery
.
• Do not use defective or damaged batteries.
• Keep batteries in storage away from metal objects
such as nails, screws or jewelry.
• Keep the batteries away from children.
Operation safety
WARNING:
Read the warning
instructions that follow before you use the
product.
• Make sure that you know which side of the product is
the front and which is the rear. Refer to the forward
direction marks on the side of the caterpillar tracks to
prevent incorrect operation.
• Make sure that the arm system is retracted when the
outriggers are retracted. This decreases the risk that
the product falls.
• During operation with a breaker or a bucket the
outriggers can come off the ground. To keep the
load on the remaining support mechanism to a
minimum, keep the outriggers near the ground.
• In some small spaces it is not possible to extend the
outriggers. If the outriggers are not extended, adapt
your operation. There is an increased risk that the
product falls when the arm system moves if the
outriggers are not extended.
• Operation with a breaker can increase the risk that
the product tilts. This can cause the outriggers to hit
the ground with a large force. Make sure that there is
no risk of damage or injury if this occurs.
• Make sure that the outriggers are extended and that
the arm system operates near the ground when the
tower rotates to the side.
• Operate the tower carefully. The direction of rotation
is not easy to know before you start to operate.
• Do not hit the work object with the arm system or the
tower. Use the installed tools only for the operation.
• During operation, make the product as level as
possible and make sure that the outriggers are fully
extended. Do not operate the arm system if the
outriggers are retracted.
• Put the product near the work object to decrease the
load on the arm system. This decreases the risk that
the product falls.
• Do not attach the product to walls or other objects to
increase the force on the work object. This can
cause overload on the product and the tool.
• To prevent overload, do not operate the cylinders in
the inner or outer end position. Keep a small
distance to the end positions.
• Do not operate the cylinders to their end positions
when you operate the breaker in an up direction.
This can cause damage to cylinders 1 and 2.
• Do not operate the cylinders to their end positions
when you operate the breaker in a down direction.
This can cause damage to cylinder 3.
• DXR 315: Do not use the telescopic arm to push the
tool against the work object.
• When the operation is completed, lower the arm
system to the ground before you stop the product.
22
1401 - 002 - 15.10.2021
