5. Turn the valve for caterpillar track tension clockwise
to close the valve.
6. Turn the lock knob clockwise.
7. Operate the outriggers up and down to do automatic
caterpillar track tension.
8. Install the left side cover.
To clean the check valves for the caterpillar
track tension (DXR 275, DXR 305, DXR 315)
1. Remove the inspection cover (A).
A
B
C
2. Pull out and turn the valve for caterpillar track
tension ¼ turn counterclockwise to lock it in an open
position (B) and (C). This releases the pressure.
3. Operate the outriggers up and down. Refer to
operate the outriggers on page 61
. The hydraulic
fluid in the system cleans the check valves.
4. Turn the valve for caterpillar track tension clockwise
and release it into closed position.
5. Operate the outriggers up and down to do automatic
caterpillar track tension.
6. Install the inspection cover.
Remote control batteries
The remote control has 2 battery slots. Each battery has
a state of charge symbol on the display and the
information center display, refer to
and
. It is not possible to operate the
remote control if the state of charge of the remote
control batteries is too low.
The operation time for fully charged remote control
batteries is approximately 12 hours. Cold weather can
decrease the operation time. If the display is used
frequently, the operation time can decrease.
If the batteries do not operate for some days, the display
for state of charge is red. They are in transportation
mode to save energy and the remote control cannot
start to operate. Before use, the batteries must be
connected to a charger.
It is necessary to charge the batteries before you use
the remote control for the first time.
To remove and install the remote control
batteries in the remote control
1. Turn the remote control to get access to the rear
side where the batteries are.
88
1401 - 002 - 15.10.2021
