Fault code number
Message in the dis-
play
Cause
Solution
8101-8107
"Receiver CAN inter-
face communication
not working"
There is an error with the CAN
bus cable between the radio
communication receiver and the
product. It can also be an internal
error.
Do a check of the product. If the
problem stays, speak to Husq-
varna service.
Transportation, storage and disposal
Transportation
WARNING:
Be careful during
transportation. The product is heavy and can
cause injury or damage if it falls or moves
during transportation.
The caterpillar tracks let you move the product shorter
distances. For longer distances, put the product on a
transportation vehicle.
• Use approved lifting equipment to attach and lift
heavy product parts.
• Always use all lifting eyes on the product when you
lift the product.
• Lift the product slowly and carefully. If the product
starts to tilt, use an alternative lifting equipment or
change the position of the arm system.
• Make sure that the parts of the product are not
damaged when you lift the product.
• Make sure that the product does not hit adjacent
objects when you lift the product.
• Use a flatbed truck or a trailer that is approved for
the weight of the product. Refer to
page 107
.
• Keep the remote control in the transportation vehicle
during transportation.
• Attach the product during transportation. Make sure
that it cannot move.
• Put some type of protection on the product during
transportation. The protection keeps natural
elements such as rain and snow away from the
product.
• Do a check of applicable road traffic regulations
before transportation of the product on public roads.
• During transportation, do regular checks to make
sure that the product is correctly attached to the
transportation vehicle.
To move the product up and down a
ramp
WARNING:
Be very careful when you
move the product up and down a ramp. The
product is heavy and there is a risk of injury
if the product falls or moves too quickly.
WARNING:
Do not walk or stay below
the product. Do not stay in the product work
Work area safety on page 20
.
WARNING:
Do not move the product
up and down a ramp when the remote
control batteries are in a low state of charge.
Power failure can occur suddenly.
• Make sure that the ramp is not damaged and has the
correct dimensions for the product.
• Make sure that there is no oil or dirt on the ramp.
• Make sure that the ramp is correctly attached to the
transportation vehicle and the ground.
• Make sure that the transportation vehicle cannot
move when you move the product up and down the
ramp.
To lift the product (DXR 145)
WARNING:
The lifting equipment must
have the correct specification to lift the
product safely. The rating plate on the
product shows the product weight. Refer to
.
WARNING:
Do not walk or stay below
or near a lifted product. Keep bystanders
away from the work area. Refer to
.
WARNING:
Do not lift a damaged
product. Make sure that the lifting eyes are
correctly installed and not damaged.
1. Retract the arm system before you lift the product.
1401 - 002 - 15.10.2021
103
