"Concrete crusher"
• "Water": Disengage or engage the water function.
.
"Grapple"
• "Water": Disengage or engage the water function.
.
"Steel shears"
• "Water": Disengage or engage the water function.
.
"Drum cutter"
• "Water": Disengage or engage the water function.
.
"Custom tool 1–3"
• "Hydraulics": The value for the hydraulic oil pressure
and the flow can be adjusted from port A to port B.
Select the direction of the hydraulic oil.
• "Grease": Adjust the quantity of grease that the
hydraulic pump supplies to the product.
• "Water": Disengage/engage the function.
• "Extra function 1": Custom tool is controlled with right
side switch on the right joystick. The value for the
hydraulic oil pressure and the flow can be adjusted
from port A to port B. Select the direction of the
hydraulic oil. "E1" is shown in the display.
• "Extra function 2": Custom tool is controlled with left
side switch on the left joystick. The value for the
hydraulic oil pressure and the flow can be adjusted
from port A to port B. Select the direction of the
hydraulic oil. "E2" is shown in the display.
Hydraulics
Extra function 1
Extra function 2
Grease
Water
"Water"
To use the water function it is necessary to install the
optional dust reduction kit. The water function is
applicable for many tools.
The water function is in operation when a drop symbol is
shown on the display with the selected tool.
• "Extended time": extended water supply after the
tool goes into standby mode.
• "On (auto)": the water supply is applied automatically
when you use the tool.
• "On (auto close)": the water supply is applied
automatically when concrete crusher closes.
• "On (auto open/close)": the water supply is applied
automatically when you use the concrete crusher.
• "On (constant)": the water supply is constant until
you stop the product or use a different tool.
• "Off": the water supply is closed.
On (auto)
Off
On (constant)
"Machine status" menu
Tools
Controls
System
Machine status
Functions
View status
Active faults
Operating time
• "View status" shows the temperature, the voltage
and the current.
• "Active faults" is a list of faults that the product finds.
The list shows all active messages. The newest
message is at the top of the list. Refer to
on the display on page 94
.
• "Operating time" shows the total operation time of
the product.
"Functions" menu
Tools
Controls
System
Machine status
Functions
Oil refill
Track tension
• The "Oil refill" fills the hydraulic oil. Refer to
check of the hydraulic oil level (DXR 145) on page
68
and
To do a check of the hydraulic oil level
(DXR 275, DXR 305, DXR 315) on page 68
.
• The "Track tension" engages the automatic track
tension. Refer to
To do automatic caterpillar track
.
1401 - 002 - 15.10.2021
37
