• Battery status (B). The same symbols are also
shown in the top bar on the display. Refer to
Symbols in the top bar on the display on page 13
.
State of charge
Symbol
There are 5 levels of charge for the
battery.
Battery fault.
/
Cable connection between the re-
mote control and the product.
There are 2 buttons for the information center display.
The left side button (C) moves to the next symbol in the
display. The right button (D) makes the selection.
To start the product (DXR 145)
WARNING:
Restart the product each
24 hours to make sure that the product
operates correctly.
1. Turn the emergency stop button (A) clockwise to
disengage the emergency stop.
A
2. Open the right hatch on the product.
3. Turn the main switch to the ON position. The
headlight comes on.
OFF
ON
4. Close the right hatch on the product.
5. Step out of the work area with the remote control.
6. Turn the machine stop button (B) clockwise to
disengage the machine stop.
B
C
D
F
E
7. If more than one product with remote control is used
in the same workplace, do this procedure to make
sure that you have the correct remote control:
a) Turn the OFF/ON/START switch to the ON
position (C) to start the remote control.
b) Push and hold the headlights button (D) until the
connected product flashes.
52
1401 - 002 - 15.10.2021
