WARNING:
Do not start the
motor before you know which
product that is connected.
8. Turn the OFF/ON/START switch to the START
position to start the motor. You will hear that the
product is on.
9. In the display (E), make sure that the radio signal or
cable connection symbol is shown. The symbols
show that the connection between the remote control
and the product is in operation.
Note:
An error message shows in the display if
there is a fault. Refer to
page 94
.
10. Push the operation mode switch (F) up to select
work mode. Push the operation mode switch down to
select transport mode. Refer to
page 60
.
To start the product (DXR 275, DXR
305, DXR 315)
WARNING:
Restart the product each
24 hours to make sure that the product
operates correctly.
1. Turn the emergency stop button (A) clockwise to
disengage the emergency stop.
A
2. Open the right hatch on the product.
3. Turn the main switch to the ON position. The
headlight comes on.
OFF
ON
4. Close the right hatch on the product.
5. Step out of the work area with the remote control.
6. Turn the machine stop button (B) clockwise to
disengage the machine stop.
B
C
D
F
E
7. If more than one product with remote control is used
in the same workplace, do this procedure to make
sure that you have the correct remote control:
a) Turn the OFF/ON/START switch to the ON
position (C) to start the remote control.
b) Push and hold the headlights button (D) until the
connected product flashes.
1401 - 002 - 15.10.2021
53
