b) Use the joysticks to extend and retract the
outriggers. Refer to
,
"Pattern 2" on page 42
and
"Pattern 3" on page
44
.
3. Do the procedure that follows for two lever control:
a) Turn the transport mode switch to two lever
control (C).
b) Use the joysticks to extend and retract the
outriggers. Refer to
.
To stop the product (DXR 145)
1. Retract the arm system until the arm system is on
the ground.
2. Set the joysticks (A) on the remote control in the
neutral position.
A
A
B
3. Turn the OFF/ON/START switch (B) to the OFF
position.
4. Step into the work area and open the right hatch on
the product.
5. Turn the main switch to the OFF position.
OFF
ON
6. Close the right hatch on the product.
7. Disconnect the power plug.
To stop the product (DXR 275, DXR
305, DXR 315)
1. Retract the arm system until the arm system is on
the ground.
2. Set the joysticks (A) on the remote control into the
neutral position.
A
A
B
3. Turn the OFF/ON/START switch (B) to the OFF
position.
4. Step into the work area and open the right hatch on
the product.
62
1401 - 002 - 15.10.2021
