Contents
Introduction..................................................................... 6
Safety..............................................................................7
Assembly........................................................................ 9
Maintenance................................................................. 10
Technical data.............................................................. 10
Contents of the EC declaration of conformity............... 12
Introduction
Product description
We have a policy of continuous product development
and therefore reserve the right to modify the design and
appearance of the products without prior notice.
Note: This manual cover both gasoline operated and
battery operated power units.
Intended use
WARNING: Use this attachment only with
products that it is intended for. Refer to the
accessory chapter in the operator's manual
of your product.
Use the attachment for edging lawns only.
Cutting attachment overview
(Fig. 1)
1. Blade
2. Grease filler cap, bevel gear
3. Bevel gear
4. Cutting attachment guard
5. Shaft
6. Drive disc
7. Support flange
8. Locknut
9. Blade bolt
10. Front guard, for battery power unit.
11. Combination wrench
12. Locking pin
13. Operator′s manual
Symbols on the cutting attachment
(Fig. 2)
Careless or incorrect use of this attachment
can result in serious or fatal injury to the
operator or others.
(Fig. 3)
Please read the operator’s manual carefully
and make sure you understand the
instructions before using the attachment.
(Fig. 4)
Please read the operator’s manual carefully
and make sure you understand the
instructions before using the attachment.
(Fig. 5)
Always wear approved hearing protection
and protective goggles or a visor. A
breathing mask should be used when there
is a risk of dust.
(Fig. 6)
Always wear approved protective gloves.
(Fig. 7)
Wear sturdy, non-slip boots.
(Fig. 8)
Rotating blade. Keep hands and feet clear.
The arrow indicates the direction of rotation.
(Fig. 9)
Watch out for thrown objects and ricochets.
(Fig. 10)
The blade continues to rotate even after the
engine/motor has stopped.
(Fig. 11)
Maximum speed of the output shaft.
(Fig. 12)
Keep a minimum of 15 m / 50 ft distance to
persons and animals during operation of the
product.
(Fig. 14)
The operator must ensure that no people or
animals come closer than 15 metres. When
several operators are working at the same
site a safety distance of at least 15 metres
must be in effect. The attachment can forci-
bly throw objects that can bounce back. This
can result in serious eye injuries if the rec-
ommended safety equipment is not used.
(Fig. 13)
The product agrees with the applicable EC
directives.
Note: Other symbols/decals on the attachment refer to
special certification requirements for certain markets.
6
1153 - 001 - 22.08.2019
