BRAKE SYSTEM 12
107
H00327-10
–
Insert the new brake linings, insert pin
4
, and mount
cotter pins
3
.
Info
Always change the brake linings in pairs.
Make sure that decoupling plate
7
is mounted
on the piston side brake lining.
–
Operate the foot brake lever repeatedly until the brake
linings are in contact with the brake disc and there is a
pressure point.
K01106-10
–
Add brake fluid to level
A
.
Brake fluid DOT 4 / DOT 5.1 (
–
Mount and tighten screw cap
1
with membrane
2
and
the O-ring.
Info
Use water to immediately clean up any brake fluid
that has overflowed or spilled.
V01358-10
(FX 450)
–
Position the vehicle upright.
–
Remove the cable tie.
–
Remove screw cap
1
with membrane
2
and the shim.
H02368-11
–
Manually press the brake caliper toward the brake disc to
push back the brake piston. Ensure that brake fluid does
not flow out of the brake fluid reservoir; extract some if
necessary.
Info
Make sure that you do not press the brake caliper
against the spokes when pushing back the brake
piston.
–
Remove cotter pin
3
.
–
Push spring plate
4
downward and remove pin
5
.
–
Remove the brake linings.
–
Clean the brake caliper and the brake caliper bracket.