Contents
Introduction..................................................................... 2
Safety..............................................................................8
Operation...................................................................... 13
Maintenance................................................................. 27
Troubleshooting............................................................ 43
Transportation, storage and disposal........................... 43
Technical data.............................................................. 48
Accessories.................................................................. 53
Introduction
California Proposition 65
WARNING!
The engine exhaust from this
product contains chemicals known
to the State of California to cause
cancer, birth defects or other
reproductive harm.
Owner responsibility
WARNING:
Cutting, especially when
DRY cutting, generates dust that comes
from the material being cut, which frequently
contains silica. Silica is a basic component
of sand, quartz, brick clay, granite and
numerous other minerals and rocks.
Exposure to excessive amount of such dust
can cause:
Respiratory disease (affecting your ability to
breathe), including chronic bronchitis,
silicosis and pulmonary fibrosis from
exposure to silica. These diseases may be
fatal;
Skin irritation and rash.
Cancer according to NTP* and IARC* */
National Toxicology Program, International
Agency for Research on Cancer.
Take precautionary steps:
Avoid inhalation of and skin contact with
dust, mist and fumes.
Wear and ensure that all bystanders wear
appropriate respiratory protection such as
dust masks designed to filter out
microscopic particles. (See OSHA 29 CFR
Part 1926.1153)
Wet cut to minimize dust emissions.
It is the owner’s/employer’s responsibility that the
operator has sufficient knowledge about how to use the
product safely. Supervisors and operators must have
read and understood the Operator’s Manual. They must
be aware of:
• The product’s safety instructions.
• The product’s range of applications and limitations.
• How the product is to be used and maintained.
National/Local regulations could restrict the use of this
product. Find out what regulations are applicable where
you work before you start using the product.
Product description
The product is a walk behind rear pivot floor saw with a
combustion engine. The center of gravity for the product
is near the rear axle which makes it easy to operate.
The product has a rear axle differential which lets the
product to turn around the rear axle. The product has an
adjustable pointer that lets you see the operation clearly
and makes it easy to cut straight. The product has a
digital display that monitors the engine functions.
WARNING:
The product can easily tilt
rearward and cause injury or damage. Be
careful when you tilt the product rearward or
lift the product.
Intended use
This product is used with diamond blades for wet cutting
to cut hard floor surface materials such as concrete,
asphalt and stone. All other use is incorrect.
The product is used in industrial operations by operators
with experience.
2
1657 - 001 - 08.09.2021
Summary of Contents for FS 4600 G II
Page 165: ...1657 001 08 09 2021 165 ...
Page 166: ...166 1657 001 08 09 2021 ...
Page 167: ...1657 001 08 09 2021 167 ...
