Checking the Safety System
The ride-on mower is equipped with a safety system that
prevents starting or driving in the following conditions.
It must only be possible to start the engine when the following
conditions are met:
• Blades shut off, blade drive not engaged.
• Parking brake applied.
The driver does not need to be seated in the driver’s seat.
Check daily to ensure that the safety system works by
attempting to start the engine when one of the conditions is
not met. Change the conditions and try again.
Check that the engine stops if you temporarily move out of
the driver’s seat while the mower blades are engaged.
Seat Microswitch
Disconnect the cable connections from the microswitch.
Press in the fasteners and remove the microswitch from the
holder.
Blades Microswitch
Loosen the left side cover.
Disconnect the connector from the microswitch.
Parking Brake Microswitch
Remove the right side cover.
Disconnect the connector from the microswitch. There are
two microswitches, one on each side.
Pedal Microswitch
Disconnect the connector from the microswitch.
Main Fuse
The main fuse is placed in a detachable holder by the battery
under the engine cover.
Type: Flat pin, 15 A.
Do not use any other type of fuse when replacing.
A blown fuse is indicated by a burnt link. Pull the fuse from the
holder when replacing it.
The fuse is there to protect the electrical system. If it blows
again shortly after replacement, it is due to a short circuit,
which must be fixed before the machine can be put into
operation again.
ELECTRICAL SYSTEM
19 – English
