Indication
Cause
Step
2 green lamps flash.
The power output is 70-90 % of the maximum available
output in operation.
N/A
3 green lamps flash.
The cutting speed is at its best performance.
The power output is 90 % of the maximum available out-
put in operation.
N/A
3 green and 1 yellow
lamps flash.
The power output drops.
Decrease the load.
3 green, 1 yellow and
1 red lamps flash.
The product is too hot.
Decrease the load or increase
the water flow or airflow to de-
crease the temperature.
All the status indica-
tion lamps flash.
The product is too hot.
Decrease the load or increase
the water flow or airflow to de-
crease the temperature.
The power is decreased.
Increase the water flow or airflow
to decrease the temperature.
The system is in automatic shutdown.
Put the power pack in a location
with lower temperature.
Refer to the operator's manual
for the power pack for more in-
structions.
Maintenance
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
For all servicing and repair work on the product, special
training is necessary. We guarantee that professional
repairs and servicing is available. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
For spare parts, speak to your Husqvarna dealer or
service agent.
Maintenance schedule
Maintenance
Daily
Weekly or each
40 h
Clean the external parts of the product.
X
Do a general inspection.
X
Lubricate the diamond chain and the guide bar to prevent corrosion.
X
Do a check of the water system.
X
Make sure that the power trigger and the power trigger lockout operate correctly
from a safety point of view.
X
Do a check of the hand guard, rear hand guard, transmission cover and spray
guard.
X
1455 - 003 - 03.03.2020
17
Summary of Contents for K 7000 Chain
Page 103: ...1455 003 03 03 2020 103 ...
