English – 25
• Remove the blade bolt by turning the bolt counter-
clockwise. Remove blade and attaching hardware: bolt,
lock washer and hardened washer.
• Remove the Mulching plug.
• Remove rear insert.
• Remove the belt cover and the stripper.
• Disconnect cable from transmission.
• Remove idler pulley from idler assembly.
• Remove belt from blade adapter / engine pulley and
idler assembly.
• Remove the old drive belt.
Replace the drive belt.
IMPORTANT! Always use genuine parts.
• Place new belt on rear transmission pulley. Be sure
the new belt is inside the tabs of the belt keeper.
• Route new belt through idler assembly to blade
adapter / engine pulley.
• Reinstall idler pulley.
• Position the blade adapter / engine pulley on the
engine crank shaft. Be sure key in blade adapter /
engine pulley and crankshaft keyway are aligned and
that the new belt is inside the tab of the belt retainer.
• Reattach cable to rear transmission and reattach
return spring to rear insert / rear transmission belt
keeper.
• Reinstall rear insert.
• Reinstall the blade. See instructions in the section
”Replacing the blades”.
• Tighten spark plug.
MAINTENANCE
Summary of Contents for LC221R
Page 27: ...English 27 ...