To adjust the handle height (LH 700)
1. Loosen the screw (A).
C
A
D
B
2. Loosen the nut (B) for the vibration damping unit (C).
3. Remove the 2 screws (D), 1 on each side of the
handle.
4. Adjust the handle height to the correct operation
position for the operator.
5. Attach and tighten the 2 screws (D).
6. Adjust the vibration damping unit (C) with the screw
(A).
7. Tighten the nut (B).
To start the product (LH 700)
WARNING: Keep your feet away from the
product during the start procedure. The
hydraulic system can cause the product to
move suddenly when the engine starts.
CAUTION: Do not use start gas. Start gas
can decrease the life of the engine.
1. Set the throttle control to idle speed.
2. Make sure that the emergency stop button is
disengaged.
3. Turn the ignition key to the ignition position (A). The
indicators for battery charge and oil pressure come
on.
A
4. Turn the ignition key to the start position (B).
B
a) When the engine starts, immediately release the
ignition key. The ignition key goes to neutral
position.
b) If the engine does not start in 10 seconds,
release the ignition key and wait 5 seconds
before you try again.
CAUTION: If the indicators for battery
charge and oil pressure do not go off
when the product starts, stop the
product. Let an approved service center
do troubleshooting and repair the
product before you start it again.
5. Let the engine operate at idle speed for 2–3 minutes.
1177 - 001 - 02.04.2020
11
