a) Turn the ignition key to the stop position.
b) Remove the ignition key to prevent accidental
start.
Maintenance
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = Refer to the instructions in the engine manual
supplied by the engine manufacturer.
General product maintenance
Before use,
each 10 h
Weekly,
each 100 h
Monthly,
each 250 h
Yearly, each
500 h
Make sure that there are no fuel or oil leaks.
*
Clean the product.
X
Make sure that nuts and screws are tightened.
*
Examine the throttle control and the control for forward
and rearward movement for damage.
*
Make sure that the throttle control and the control for for-
ward and rearward movement can move smoothly.
*
Lubricate the controls and linkages.
*
Examine the safety straps for damage. Replace if it is
necessary.
X
Examine the vibration damping units for damage.
X
Make sure that the scrapers do not touch the drums. Ad-
just the clearance if it is necessary.
X
Fill the water tank with clean water.
*
Examine all rubber hoses and rubber elements for dam-
age. Replace if it is necessary.
X
X
X
Do a check of the hydraulic oil level.
X
Do a check of the battery.
X
X
Replace the oil in the eccentric element.
X
Examine and clean the hydraulic oil cooler.
O
1503 - 001 - 12.11.2020
11
