Operation
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To do before you operate the product
• Read the operator's manual carefully and make sure
that you understand the instructions.
• Read the engine manual that is supplied by the
engine manufacturer.
• Do the daily maintenance. Refer to
.
• Make sure that the locking knob for the cover is fully
tightened and not damaged.
To start the product
1. Set the throttle control in the start position.
2. If the engine is cold, push the primer bulb 5 times.
3. Set the choke control in the correct position.
a) If the engine is cold, close the choke.
b) If the engine is warm or the ambient temperature
is high, open the choke.
4. Pull the starter rope handle slowly until you feel
resistance.
5. Release the starter rope handle to let the starter
rope go back.
6. Pull the starter rope handle until the engine starts.
7. Open the choke control gradually until it is fully open.
8. Let the engine operate at idle speed for 2–3 minutes
before you apply full throttle.
957 - 002 - 14.10.2019
9
