Contents
Introduction..................................................................... 2
Safety..............................................................................7
Assembly...................................................................... 10
Operation...................................................................... 12
Maintenance................................................................. 19
Troubleshooting............................................................ 21
Transportation, storage and disposal........................... 21
Technical data.............................................................. 22
Introduction
Owner responsibility
WARNING: Cutting, especially when DRY
cutting, generates dust that comes from the
material being cut, which frequently contains
silica. Silica is a basic component of sand,
quartz, brick clay, granite and numerous
other minerals and rocks. Exposure to
excessive amount of such dust can cause:
Respiratory disease (affecting your ability to
breath), including chronic bronchitis, silicosis
and pulmonary fibrosis from exposure to
silica. These diseases may be fatal;
Skin irritation and rash.
Cancer according to NTP* and IARC* */
National Toxicology Program, International
Agency for Research on Cancer.
WARNING: Take precautionary steps:
Avoid inhalation of and skin contact with
dust, mist and fumes.
Make sure that all bystanders wear
appropriate respiratory protection such as
dust masks designed to filter out
microscopic particles. (See OSHA 29 CFR
Part 1926.1153)
To minimize dust emissions, wet cut when
feasible. If dry cutting is necessary, use the
Vac unit.
It is the owner’s/employer’s responsibility that the
operator has sufficient knowledge about how to use the
product safely. Supervisors and operators must have
read and understood the Operator’s Manual. They must
be aware of:
• The products’s safety instructions.
• The products’s range of applications and limitations.
• How the product is to be used and maintained.
National legislation could regulate the use of this
product. Find out what legislation is applicable in the
place where you work before you start using the
product.
Intended use
This product is designed and intended for cutting tile,
stone, block and brick. All other use is improper.
The product is intended for use in industrial applications
by experienced operators.
Product description
The MS 610 G, MS 610 are powerful transportable
masonry and stone cutting-off saws, which are set up
stationary during work. The MS 610 is the electrical
version and the MS 610 G is the gasoline powered
version.
Values such as high performance, reliability, innovative
technology, advanced technical solutions and
environmental considerations distinguish Husqvarna's
products. Safe operation of this product requires the
operator to read this manual carefully. Contact your
dealer or Husqvarna for more information.
Some of the unique features of your product are
described below.
• The product has a capacity to cut material thickness
over 7.5”(191 mm) in one cut and 15”(381 mm) in
two cuts.
• Flexible plunge cutting.
• The large size blade flange Ø 3” (82mm) provides a
large and good support surface for the blade.
• Blade clutch (option)
2
271 - 002 - 12.06.2018
Summary of Contents for MS 610
Page 3: ...Product overview MS 610 G 271 002 12 06 2018 3 ...
Page 25: ...Présentation du produit MS 610 G 271 002 12 06 2018 25 ...
Page 49: ...Descripción general MS 610 G 271 002 12 06 2018 49 ...
Page 72: ...Original instructions Instructions d origine Instrucciones originales 1158948 49 2018 06 25 ...
