7. Attach the locking pin on the adjustment lever for
cutting height.
8. Hold the front wheel with 1 hand and remove the
locking pin with the other hand.
9. Move the distance rings up or down, refer to the
table below. The distance rings have 2 thicknesses,
(A) is 15 mm/0.6 in. thick and (B) is 10 mm/0.4 in.
thick.
A
B
10. Attach the locking pin on top of the front wheel.
11. Do step 8-10 again with the second wheel.
12. Adjust the parallelism of the cutting deck. Refer to
adjust the parallelism of the cutting deck on page
59
.
To get a good cutting result
• For best performance, do maintenance on the
product regularly as given in the maintenance
schedule. Refer to
40
.
• Do not cut a wet lawn. Wet grass can give a bad
cutting result.
• Start with a high cutting height and decrease it
gradually.
• Cut with blades that rotate at high speed (highest
permitted engine speed, refer to
page 67
). Move the product forward at low speed. If
the grass is not too high and thick, you can get a
good cutting result also at a higher speed.
• Cut the grass in an irregular pattern.
• To get the best cutting result, cut the grass
frequently and use the BioClip
®
function.
1591 - 005 - 20.05.2021
39
