Transportation, storage and disposal
Transportation of batteries
• The supplied 48 V batteries obey the requirements
of the Dangerous Goods Legislation.
• Obey the special requirement for packaging and
labels for commercial transportation by third parties
and forwarding agents.
• Speak to a person with special training in dangerous
material before you send the product. Obey all
applicable national regulations.
• Use tape on open contacts when you put the battery
in a package. Put the battery in a tight package to
prevent movement.
To safely attach the product on a trailer for
transport
Before you attach the product, you must read and
understand the safety chapter. Refer to
on page 27
.
WARNING:
The parking brake is not
sufficient to lock the product during
transport. Attach the product tightly to the
load area.
Equipment: 4 approved straps and 4 wheel chocks.
1. Park the product in the center of the load area.
WARNING:
For transport in
transport vehicles with a cover. Make
sure that the product is cool before you
put the product in the transport vehicle.
2. Make sure that the center of gravity of the product is
above the wheel axle of the transport vehicle. If a
trailer is used for transport, make sure that the down
force on the tow bar is correct.
3. Apply the parking brake.
4. Lower the cutting deck to the float position.
5. Remove all loose objects.
6. Put the first strap through the rear transmission
frame.
7. Put the second strap through the rear transmission
frame.
8. Attach the straps to the load area.
9. Tighten the straps rearward to attach the product to
the load area.
10. Attach the third strap to 1 of the transport eyelets.
1591 - 005 - 20.05.2021
65
